Lexus ES: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABC | Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete | A beam axis inspection has not been performed | Blind spot monitor sensor LH |
PROCEDURE
| 1. | PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION) |
(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream.
HINT:
Refer to Blind Spot Monitor Beam Axis Inspection.
Click here .gif)
| NEXT |  | END |
READ NEXT:
Short to GND or Open in Buzzer (C1ABE)
DESCRIPTION
DTC C1ABE is stored when the blind spot monitor sensor LH detects a short to ground or open in the RCTA buzzer (blind spot monitor buzzer) circuit.
DTC No. Detection Item DTC
Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer teste
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer teste
SEE MORE:
Components
COMPONENTS ILLUSTRATION *A w/o Headup Display *B w/ Headup Display *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR OPENING TRIM COVER LH *3 FRONT DOOR SCUFF PLATE LH *4 HAZARD WARNING SIGNAL SWITCH ASSEMBLY *5 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY *6 INSTRUMEN
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE CHART Adaptive Variable Suspension System DTC Chart Malfunction Item Fail-safe Operation C1715 C1716 C1717 Acceleration sensor circuit Partial control continues. C1731 C1732 C1733 C1734 Absorber control actuator circuit Control stops. C1781 Abso
