Lexus ES manuals

Lexus ES: Black Screen

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Gasoline Model) / Black Screen

PROCEDURE

1.

CHECK DISPLAY SETTING

(a) Check that the display is not in screen off mode.

OK:

The display setting is not in screen off mode.

NG

CHANGE SCREEN TO SCREEN ON MODE
OK

2.

CHECK IMAGE QUALITY SETTING

(a) Check that the screen color quality can be set.

OK:

Setting is possible.

OK

SET SCREEN COLOR QUALITY TO NORMAL
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Camera ECU Malfunction (C1610)

DESCRIPTION This DTC is stored when a malfunction occurs in the parking assist monitor system*1 or panoramic view monitor system*2. DTC No. Detection Item DTC Detection Condition Trouble Area

 CD/DVD Sound Skips

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Cellular Phone Inspection

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is necessa

SEE MORE:

 Terminals Of Ecu

TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P22 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness

 Installation

INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY (a) Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts. Torque: 6.0 N·m {61 kgf·cm, 53 in·lbf} (b) Connect the transmission con

© 2016-2025 Copyright www.lexguide.net