Lexus ES: Backup Battery Internal Electronic Failure (B15CC49)
DESCRIPTION
This DTC is set when the DCM (telematics transceiver) detects one of the following:
-
The mobilephone battery voltage drops or the mobilephone battery malfunctions.
-
The mobilephone battery temperature is (temporarily) high.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
B15CC49 | Backup Battery Internal Electronic Failure | Mobilephone battery malfunction | -
Mobilephone battery
-
DCM (telematics transceiver)
|
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here
PROCEDURE
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK | | USE SIMULATION METHOD TO CHECK |
NG | | |
2. | CHECK MOBILEPHONE BATTERY |
(a) Replace the mobilephone battery with a normal one and check if the same problem occurs again.
Click here
NOTICE:
-
The mobilephone battery must not be replaced while an ACN call is in progress.
Click here
-
After replacing the mobilephone battery, perform initialization.
Click here
(b) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(c) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
OK | | PERFORM INITIALIZATION |
NG | | |
3. | REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
-
The power switch must be off.
-
Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT | | PERFORM DCM ACTIVATION |
READ NEXT:
DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone and GPS antenna assembly (for Front Side). DTC No. Detection Item DTC Detection Condition Trouble Area B153711
DESCRIPTION This DTC is stored when the DCM (telematics transceiver) detects an open or short in the manual (SOS) switch red indicator circuit of the manual (SOS) switch. The manual (SOS) switch red i
DESCRIPTION This DTC is set when the DCM (telematics transceiver) detects an open or short in the manual (SOS) switch green indicator circuit of the manual (SOS) switch. The manual (SOS) switch green
SEE MORE:
WHEN AUXILIARY BATTERY IS DISCHARGED WHEN AUXILIARY BATTERY IS DISCHARGED (a) When the auxiliary battery is discharged. NOTICE: The booster terminal can only be used to rescue this vehicle and can not be used to rescue another vehicle with a discharged battery. HINT: The following problems indicate
DTC SUMMARY MALFUNCTION DESCRIPTION If an overvoltage malfunction occurs in the boost converter, the motor generator control ECU (MG ECU) detects the malfunction and stores this DTC. The cause of this malfunction may be one of the following: Internal inverter malfunction
Inverter with converter a
© 2016-2025 Copyright www.lexguide.net
