Lexus ES: Active Grille Air Shutter "A" Actuator Stuck Closed (P059F73,...,P05B131)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the grille shutter system.
| DTC No. | Detection Item | Note |
|---|---|---|
| P059F73 | Active Grille Air Shutter "A" Actuator Stuck Closed | The ECM stores this DTC as an SFI system DTC* |
| P05A072 | Active Grille Air Shutter "A" Actuator Stuck Open | The ECM stores this DTC as an SFI system DTC* |
| P05A074 | Active Grille Air Shutter "A" Actuator Slipping | The ECM stores this DTC as an SFI system DTC* |
| P05A211 | Active Grille Air Shutter "A" Circuit Short to Ground | The ECM stores this DTC as an SFI system DTC* |
| P05A212 | Active Grille Air Shutter "A" Circuit Short to Battery | The ECM stores this DTC as an SFI system DTC* |
| P05A213 | Active Grille Air Shutter "A" Circuit Open | The ECM stores this DTC as an SFI system DTC* |
| P05A27E | Active Grille Air Shutter "A" Actuator Stuck On | The ECM stores this DTC as an SFI system DTC* |
| P05A27F | Active Grille Air Shutter "A" Actuator Stuck Off | The ECM stores this DTC as an SFI system DTC* |
| P05B112 | Active Grille Air Shutter "B" Circuit Short to Battery | The ECM stores this DTC as an SFI system DTC* |
| P05B114 | Active Grille Air Shutter "B" Circuit Short to Ground or Open | The ECM stores this DTC as an SFI system DTC* |
| P05B131 | Active Grille Air Shutter "B" No Signal | The ECM stores this DTC as an SFI system DTC* |
-
*: Click here
.gif)
(w/ Canister Pump Module), (w/o Canister Pump Module)
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Check for DTCs.
Powertrain > Engine > Trouble Codes| NEXT | .gif) | GO TO SFI SYSTEM |
READ NEXT:
Lost Communication between Hybrid Powertrain Control Module and Active Grille Air Shutter Missing Message (U129387)
DESCRIPTION This DTC is stored if a communication malfunction occurs between the hybrid vehicle control ECU and swing grille actuator assembly. DTC No. Detection Item DTC Detection Condition
Grille Shutter does not Operate
DESCRIPTION The swing grille actuator assembly receives signals from the ECM, hybrid vehicle control ECU and air conditioning amplifier assembly via CAN communication. Based on these signals, the swin
Luggage Compartment Door Outside Garnish
ComponentsCOMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY *2 CLIP ● Non-reusable part - - RemovalREMOVAL PROCEDURE 1. REMOVE REAR LIGHT ASSE
SEE MORE:
System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Certification ECU (smart key ECU assembly) Main body ECU (multiplex network body ECU) Luggage electrical key switch signal CAN Combination meter assembly Main body ECU (multiplex
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission wire removal/installation are shown below. Necessary Procedures After Parts Removed/Install
