Lexus ES: ABS Solenoid Control Module Actuator Stuck On (C143A7E,C143A7F,C143D49,C14DA14)
DESCRIPTION
The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly. The ABS solenoid relay supplies power to each solenoid.
The skid control ECU (brake actuator assembly) detects an ABS solenoid relay malfunction by performing a self check and relay operation check.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C143A7E | ABS Solenoid Control Module Actuator Stuck On | When an ABS solenoid relay OFF request is sent, the ABS solenoid relay remains ON for 0.065 seconds or more. | Skid control ECU (brake actuator assembly) |
| C143A7F | ABS Solenoid Control Module Actuator Stuck Off | When an ABS solenoid relay ON request is sent, the ABS solenoid relay remains OFF for 0.015 seconds or more. | Skid control ECU (brake actuator assembly) |
| C143D49 | ABS Solenoid Control Module Internal Electronic Failure | A malfunction in the ABS solenoid relay drive circuit is detected during the self test. | Skid control ECU (brake actuator assembly) |
| C14DA14 | ABS Solenoid Supply Voltage Circuit Short to Ground or Open | The ABS solenoid voltage is less than 40% of the +BS voltage for 0.185 seconds or more. | Skid control ECU (brake actuator assembly) |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Click here .gif)
PROCEDURE
| 1. | REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the brake actuator assembly.
Click here
| NEXT |  | END |
READ NEXT:
Yaw Rate Sensor Circuit Voltage Out of Range (C00631C)
DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) calibrates the sensitivity of the
Yaw Rate Sensor Circuit Intermittent (C00631F,C006396,C05201F)
DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. These DTCs are stored when the skid control ECU (brake actuator assembly) receive
Left Front Wheel Speed Sensor Circuit Voltage Out of Range (C05001C)
DESCRIPTION Refer to DTC C050012 Click here DTC No. Detection Item DTC Detection Condition Trouble Area C05001C Left Front Wheel Speed Sensor Circuit Voltage Out of Range
When th
SEE MORE:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected: System See Procedure Lane Control System (for Gasoline Model)
Transmitter ID1 Error (C2141-C2144)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tir
