Lexus ES: 2gr-fks Battery
READ NEXT:
Components
COMPONENTS
ILLUSTRATION
*A
w/ Battery Insulator
-
-
*1
BATTERY
*2
NEGATIVE BATTERY TERMINAL
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced battery
Installation
INSTALLATION
PROCEDURE
1. INSTALL BATTERY
(a) w/ Battery Insulator
(1) Install the battery insulator to the battery.
(b) Install the battery to the vehicle.
(c) Install the No. 2 battery clamp t
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING WHEEL SWITCH HOUSING *a Component without harness connected (Steering Wheel Switch Housing) - - (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Light Switch Circuit Tester Connection Condition
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP (a) Align the alignment mark on the front door opening trim weatherstrip with the flange on the
© 2016-2025 Copyright www.lexguide.net
