Lexus ES: Weather and traffic information cannot be obtained
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
.gif)
-
When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
PROCEDURE
| 1. | CHECK COVERAGE AREA |
(a) w/ Manual (SOS) Switch: Check that the current position of the vehicle is within the HD weather and traffic or DCM communication function coverage area.
w/o Manual (SOS) Switch: Check that the current position of the vehicle is within the HD weather and traffic coverage area.
OK:
Vehicle is within coverage area.
| NG |  | MOVE TO WITHIN COVERAGE AREA |
|
| 2. | CHECK SYMPTOMS |
(a) Check for symptoms (poor sound quality, sounds cannot be heard, etc.) during conventional FM radio broadcasting.
| Result | Proceed to |
|---|---|
| Symptoms occur | A |
| Symptoms do not occur | B |
| A | | GO TO "RADIO BROADCAST CANNOT BE RECEIVED OR POOR RECEPTION" IN PROBLEM SYMPTOMS TABLE |
|
| 3. | CHECK SYMPTOMS |
(a) Check for symptoms (Unable to connect to call center, etc.) with an ordinary safety connect.
| Result | Proceed to |
|---|---|
| Symptoms occur | A |
| Symptoms do not occur | B |
| A | | GO TO "UNABLE TO CONNECT TO CALL CENTER" IN PROBLEM SYMPTOMS TABLE |
| B | | REPLACE RADIO RECEIVER ASSEMBLY |
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY *2 INSTRUMENT PANEL FINISH PANEL END LH *3 INSTRUMENT PANEL FINISH PANEL END RH *4 REAR UPPER CONSOLE
Installation
INSTALLATION PROCEDURE 1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY (a) Install the remote operation controller assembly with the 4 screws as shown in the illustration. Install in this Direc
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY (a) Install the front lower arm bushing stopper to the front lower No. 1 suspension ar
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING WHEEL SWITCH HOUSING *a Component without harness connected (Steering Wheel Switch Housing) - - (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Light Switch Circuit Tester Connection Condition
