Lexus ES manuals

Lexus ES: Voice is not Recognized

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Hv Model) / Voice is not Recognized

PROCEDURE

1.

CHECK CONDITION

(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

OK:

Voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Weather and traffic information cannot be obtained

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Remote Touch

 Components

COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY *2 INSTRUMENT PANEL FINISH PANEL END LH *3 INSTRUMENT PANEL FINISH PANEL END RH *4 REAR UPPER CONSOLE

SEE MORE:

 Pressure Control Solenoid "A" Circuit Short to Ground or Open (P074514)

DESCRIPTION Refer to DTC P074512. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P074514 Pressure Control Solenoid "A" Circuit Short to Ground or Open While the vehicle is being driven so that gear changes occur, a short to ground or o

 Terminals Of Ecu

TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the J28 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the co

© 2016-2026 Copyright www.lexguide.net