Lexus ES manuals

Lexus ES: Voice is not Recognized

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System (for Gasoline Model) / Voice is not Recognized

PROCEDURE

1.

CHECK CONDITION

(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

OK:

Voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Audio And Visual System (for Hv Model)

 AVC-LAN Circuit

DESCRIPTION Each unit of the audio and visual system connected to the AVC-LAN (communication bus) transmits signals via AVC-LAN communication. If a short to +B or short to ground occurs in an AVC-LAN

 Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION This DTC is stored when a malfunction occurs in the stereo component amplifier assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15A3 Stereo Component A

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL RADIATOR SHUTTER SUB-ASSEMBLY (a) Engage the 2 guides as shown in the illustration. Install in this Direction (b) Install the radiator shutter sub-assembly with the 3 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (c) Engage the clamp. (d) Connect the c

 Red Indicator Remains On

DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE 1. CHECK DTC (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the e

© 2016-2026 Copyright www.lexguide.net