Lexus ES manuals

Lexus ES: Voice Guidance does not Function

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System (for Hv Model) / Voice Guidance does not Function

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio receiver assembly may not operate normally.

PROCEDURE

1.

CHECK VOICE GUIDANCE SETTING

(a) Check that the voice guidance setting is not off.

OK:

Voice guidance setting is not off.

NG

CHANGE THE VOICE GUIDANCE SETTING TO ON
OK

2.

CHECK AUDIO FUNCTION

(a) Check that sound can be heard from a front speaker.

OK:

Sound can be heard.

OK

REPLACE RADIO RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Voice is not Recognized

PROCEDURE 1. CHECK CONDITION (a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation. OK: Voice command is recognized normally. HINT:

 Front Door Speaker

 Components

COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *C for 17 Speakers - - *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 FR

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Inspect the fuses and relays related to this system before inspecting the suspected areas below. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of

 Inspection

INSPECTION CAUTION / NOTICE / HINT NOTICE: Make sure the contact surface of the cam timing control motor with EDU assembly (the surface that contacts the No. 2 timing gear cover assembly) is free of foreign matter. If the cam timing control motor with EDU assembly has been struck or dropped, re

© 2016-2026 Copyright www.lexguide.net