Lexus ES: Voice is not Recognized
PROCEDURE
(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
OK:
Voice command is recognized normally.
HINT:
-
When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.
-
If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
-
The system cannot recognize voice commands when multiple people are speaking simultaneously.
-
If the speaking speed is too fast or too slow, the recognition rate may decrease.
-
The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
| OK | | END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION) |
READ NEXT:
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *C for 17 Speakers - - *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 FR
INSPECTION PROCEDURE 1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the s
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep
PARTS LOCATION ILLUSTRATION *1 CANISTER (CHARCOAL CANISTER ASSEMBLY) *2 FUEL TANK CAP ASSEMBLY *3 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) *4 PURGE VALVE (PURGE VSV) *5 ECM *6 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - EFI-MAIN NO. 1 RELAY - EFI-MAIN NO. 1
© 2016-2026 Copyright www.lexguide.net
