Lexus ES: Vacuum Pump(for Tmmk Made)
READ NEXT:
COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 NO. 2 SURGE TANK STAY *3 EARTH WIRE - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turni
INSTALLATION CAUTION / NOTICE / HINT HINT: Refer to the illustration to confirm the type of vacuum pump assembly. *A for Type A *B for Type B *a Label - - PROCEDURE 1. INSTALL V
ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Click here 2. REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY Click here 3. OPERATION CHECK (a) Slide th
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY CAUTION:
Do not put your hands into the water that has been heated for the inspection.
Touching the heated water could result in burns.
HINT: The valve opening temperature is inscribed on the water inlet with therm
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during steering pad switch assembly removal/installation are shown below. Necessary Procedures After Parts Remo
© 2016-2024 Copyright www.lexguide.net