Lexus ES: Thermostat
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 FRONT NO. 1 ENGINE MOUNTING BRACKET LH *3 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *4 GASKET *5 WATER BY-PASS HOSE *6 WIRE HARNE
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during wate
Inspection
INSPECTION PROCEDURE 1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (a) Check the valve opening. HINT: The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly.
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear brake removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Rep
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
Do not rotate the spiral cable with sensor sub-assembly without th
© 2016-2026 Copyright www.lexguide.net
