Lexus ES: System information not received (C13AE)
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13AE | System information not received | Both of following conditions are met:
|
| DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
CAUTION / NOTICE / HINT
NOTICE:
The parking brake indicator light blinks (red) when the power switch is turned on (IG) after replacing the parking brake ECU (brake actuator assembly). Operate the electric parking brake switch assembly to turn off the parking brake indicator light (red).
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Check for DTC.
Chassis > Electric Parking Brake > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C13AE and a CAN DTC are output at the same time | A |
| DTC C13AE is output and the MIL is illuminated | B |
| Only DTC C13AE is output | C |
| DTCs are not output | D |
| A | .gif) | GO TO CAN COMMUNICATION SYSTEM |
| B | | GO TO HYBRID CONTROL SYSTEM |
| C | | REPLACE PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY) |
| D | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
EPB Switch Malfunction (C13B4)
DESCRIPTION When the electric parking brake switch is pushed, a lock request signal is sent from the parking brake ECU (brake actuator assembly) to the parking brake actuator assembly. When the electr
Deceleration Sensor (C1245)
DESCRIPTION The parking brake ECU (brake actuator assembly) receives vehicle tilt angle information from the deceleration sensor (airbag ECU assembly) via CAN communication. DTC No. Detection Ite
Data List / Active Test
DATA LIST / ACTIVE TEST READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part
SEE MORE:
Outside Handle Foot Light Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the outside handle foot lights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here PROCEDURE 1. PERFORM ACTIVE TEST USING TECH
Remote Up / Down Function does not Operate
DESCRIPTION When the power switch on (IG), the multiplex network master switch assembly sends remote up and down signals to each power window regulator motor assembly via LIN communication. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
The power window control system uses the LIN communication
