Lexus ES manuals

Lexus ES: System Description

SYSTEM DESCRIPTION

GENERAL

The windshield deicer system uses thin heater wires attached to the inside of the windshield glass to help deice the window surface more quickly. An indicator light illuminates while the system is operating. This system automatically turns off after approximately 15 minutes.

NOTICE:

If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the windshield deicer system may not operate.

FUNCTION OF MAIN COMPONENT

Component

Outline

Front Wiper Deicer Switch (Multi-display Assembly)

Sends signals to the air conditioning amplifier assembly to operate the windshield deicer system.

Air Conditioning Amplifier Assembly

Sends windshield deicer activation request signals to the DEICER relay.

DEICER Relay

Receives windshield deicer activation request signals from the air conditioning amplifier assembly and supplies power to the windshield deicer wire (windshield glass).

Windshield Deicer Wire (Windshield Glass)

Receives power from the DEICER Relay and heats the windshield deicer wire (windshield glass).

READ NEXT:

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the windshield deicer system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

 Operation Check

OPERATION CHECK CHECK WINDSHIELD DEICER SYSTEM (a) Turn the power switch on (IG). (b) Check that the windshield deicer wire (windshield glass) becomes warm by operating the front wiper deicer switch.

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system

SEE MORE:

 Input/Turbine Speed Sensor "A" Circuit Short to Battery (P071512,P071514,P071531)

DESCRIPTION The transmission revolution sensor (NT) detects the input shaft rotation speed and sends it to the ECM. Based on the transmission revolution sensor (NT) signal and the transmission revolution sensor (NC) signals, the ECM controls engine torque and shift timing. Based on the input shaft r

 Diameter of the Tire is not Uniform (C1337)

DESCRIPTION The 4WD ECU assembly outputs this DTC if a difference in tire size is detected. DTC No. Detection Item DTC Detection Condition Trouble Area C1337 Diameter of the Tire is not Uniform When the following continues for 36 seconds or more: At a vehicle speed of 30 km/h (19 mp

© 2016-2026 Copyright www.lexguide.net