Lexus ES: Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)
DESCRIPTION
The forward recognition camera and millimeter wave radar sensor assembly communicate via CAN communication. If there is an error in the communication with the millimeter wave radar sensor assembly, the forward recognition camera stores DTC U023587.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U023587 | Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message | 2 seconds after the power switch is turned on (IG), when the lane control system is on, a communication error is detected between the millimeter wave radar sensor assembly and the forward recognition camera for approximately 5 seconds or more. | Pre-collision system |
PROCEDURE
| 1. | GO TO PRE-COLLISION SYSTEM |
HINT:
If DTC U023587 is output by the lane control system, perform troubleshooting for the pre-collision system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. If the forward recognition camera cannot store the vehicle inform
Internal Control Module Software Incompatibility Invalid / Incompatible Software Component (U030057)
DESCRIPTION The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. If the vehicle information stored in the forward recognition came
Steering Pad Switch Circuit
DESCRIPTION The forward recognition camera receives LTA main switch signals from the steering pad switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: The vehicle is equipped with a Supple
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below
Switch Failure (B2342)
DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) detects that the panoramic moon roof switch (map light sub-assembly) is stuck for 30 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2342 Switch Failure Sliding
