Lexus ES: Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
(a) Disconnect the G6 radio receiver assembly connector.
(b) Disconnect the G8 No. 1 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G6-14 (ADPG) - G8-2 (ADPG) | Always | Below 1 Ω |
| G6-10 (AGND) - G8-7 (AGND) | Always | Below 1 Ω |
| G6-12 (VAR+) - G8-6 (VAR+) | Always | Below 1 Ω |
| G6-11 (VAL+) - G8-1 (VAL+) | Always | Below 1 Ω |
| G6-13 (VA-) - G8-5 (VA-) | Always | Below 1 Ω |
| G6-14 (ADPG) or G8-2 (ADPG) - Body ground | Always | 10 kΩ or higher |
| G6-10 (AGND) or G8-7 (AGND) - Body ground | Always | 10 kΩ or higher |
| G6-12 (VAR+) or G8-6 (VAR+) - Body ground | Always | 10 kΩ or higher |
| G6-11 (VAL+) or G8-1 (VAL+) - Body ground | Always | 10 kΩ or higher |
| G6-13 (VA-) or G8-5 (VA-) - Body ground | Always | 10 kΩ or higher |
| OK |  | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
READ NEXT:
Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is
Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio receiver assembly. If there is an open in the circuit, the audio system cannot be operated using t
Stereo Jack Adapter Light does not Illuminate
DESCRIPTION Power is supplied to the No. 1 stereo jack adapter assembly illumination from the radio receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that ar
SEE MORE:
Multi-information display
Display and menu icons
■ Display
By selecting menu icons on the multi-information
display, a variety of driving-related
information can be displayed.
The multi-information display can also
be used to change display settings and
other vehicle settings.
Warning or suggestion/advice pop-u
Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Ground (P032511)
DESCRIPTION A flat-type knock control sensor (non-resonant type) has a structure that can detect vibrations between approximately 5 and 23 kHz. The knock control sensor is fitted onto the engine block to detect engine knocking. The knock control sensor contains a piezoelectric element which generate
