Lexus ES manuals

Lexus ES: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.

CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END

NG

2.

CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END

NG

3.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

MALFUNCTION IN PORTABLE PLAYER

READ NEXT:

 Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre

 Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND

 Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU

DESCRIPTION This circuit includes the navigation ECU and radio receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disco

SEE MORE:

 High Voltage Power Resource Circuit Voltage Sensor after Boosting Malfunction (P1C8349)

DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU monitors the high-voltage wiring between the HV battery and inverter with converter assembly and detects a power supply malfunction. The cause of this malfunction may be one of the following: Inverter voltage sensor (VH) internal ci

 Pressure Control Solenoid "A" Actuator Stuck Off (P07457F)

DESCRIPTION Based on signals from the transmission revolution sensors (NT and NC), the actual gear is detected. The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical malfunctions of the solenoid valves, transmission valve body assembly and automatic transaxl

© 2016-2026 Copyright www.lexguide.net