Lexus ES: Vehicle Speed Sensor (C1A45)
DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
Blind Spot Monitor Master| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU |
|
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK OTHER DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Chassis > ABS/VSC/TRAC > Trouble CodesOK:
Electronically controlled brake system DTCs are not output.
| NG | .gif) | GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
.gif)
|
.gif)
| 2. | CHECK DTC |
(a) Turn the power switch off.
(b) Turn the power switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC C1A45 is output ("Blind Spot Monitor Master") | B |
| DTC C1A45 is output ("Blind Spot Monitor Slave") | C |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE BLIND SPOT MONITOR SENSOR RH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR LH |
READ NEXT:
Yaw Rate Sensor (C1A46)
DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master DTC No. Det
Steering Angle Sensor (C1A47)
DESCRIPTION The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Conditio
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble A
SEE MORE:
Evaporative Emission System Leak Detection Reference Orifice Low Flow (P043E00,P043F00,P24007E,P24007F,P24187E)
DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P043E00 Evaporative Emission System Leak Detection Reference Orifice Low Flow Reference orifice clogged during key-off EVAP monitor
Canister pump module
Wire harness or connector (ca
Cold Start Ignition Timing Performance (P050B00)
MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 (14°F) or higher, and less than 50°C (122°F). If certain conditions are met, a DTC is stored after the engine idles for 13 seconds (2 trip detection logic). This DTC is designed to monitor th
