Lexus ES manuals

Lexus ES: RL Speed Sensor Wrong Installation (X0453)

DESCRIPTION

Code

Tester Display

Measurement Item

Trouble Area

X0453

RL Speed Sensor Wrong Installation

History of rear speed sensor LH being installed incorrectly

Rear Speed Sensor LH

PROCEDURE

1.

CHECK FOR DTCs (HEALTH CHECK)

(a) Perform the Health Check using the Techstream.

Result

Proceed to

DTCs are not output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A

2.

CHECK PART NUMBER (REAR SPEED SENSOR LH)

(a) Check that the rear speed sensor LH is installed.

OK:

Proper rear speed sensor LH is installed.

NOTICE:

If it is necessary to remove components in order to check the rear speed sensor LH, follow the relevant installation and removal procedures and precautions for those components.

HINT:

The rear speed sensor LH and rear speed sensor rotor LH are incorporated into the rear axle hub and bearing assembly LH. (for 2WD)

If the rear speed sensor LH and rear speed sensor rotor LH need to be replaced, replace the rear axle hub and bearing assembly LH. (for 2WD)

NG

REPLACE REAR SPEED SENSOR LH

OK

3.

CLEAR VEHICLE CONTROL HISTORY

(a) Using the Techstream, clear the Vehicle Control History.

Chassis > Brake > Utility

Tester Display

Vehicle Control History (RoB)

NEXT

4.

CHECK VEHICLE CONTROL HISTORY

(a) Using the Techstream, check for Vehicle Control History.

Chassis > Brake > Utility

Tester Display

Vehicle Control History (RoB)

HINT:

The rear speed sensor LH and rear speed sensor rotor LH are incorporated into the rear axle hub and bearing assembly LH. (for 2WD)

If the rear speed sensor LH and rear speed sensor rotor LH need to be replaced, replace the rear axle hub and bearing assembly LH. (for 2WD)

Result

Proceed to

X0453 is not output

A

X0453 is output

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE REAR SPEED SENSOR LH

READ NEXT:

 RR Speed Sensor Wrong Installation (X0454)

DESCRIPTION Code Tester Display Measurement Item Trouble Area X0454 RR Speed Sensor Wrong Installation History of rear speed sensor RH being installed incorrectly Rear Speed Sensor

 RR Speed Sensor Wrong Installation (X0454)

DESCRIPTION Code Tester Display Measurement Item Trouble Area X0454 RR Speed Sensor Wrong Installation History of rear speed sensor RH being installed incorrectly Rear Speed Sensor

 Slip Indicator Light does not Come ON

DESCRIPTION The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing th

SEE MORE:

 Data List / Active Test

DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. The actual values may differ from the values listed in the chart under "Reference Value"

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required befor

© 2016-2024 Copyright www.lexguide.net