Lexus ES: RR Speed Sensor Wrong Installation (X0454)
DESCRIPTION
| Code | Tester Display | Measurement Item | Trouble Area |
|---|---|---|---|
| X0454 | RR Speed Sensor Wrong Installation | History of rear speed sensor RH being installed incorrectly | Rear Speed Sensor RH |
PROCEDURE
| 1. | CHECK FOR DTCs (HEALTH CHECK) |
(a) Perform the Health Check using the Techstream.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
| B |  | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
| 2. | CHECK PART NUMBER (REAR SPEED SENSOR RH) |
(a) Check that the rear speed sensor RH is installed.
OK:
Proper rear speed sensor RH is installed.
NOTICE:
If it is necessary to remove components in order to check the rear speed sensor RH, follow the relevant installation and removal procedures and precautions for those components.
HINT:
The rear speed sensor RH and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.
If the rear speed sensor RH and rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.
| NG | | REPLACE REAR SPEED SENSOR RH |
|
| 3. | CLEAR VEHICLE CONTROL HISTORY |
(a) Using the Techstream, clear the Vehicle Control History.
Chassis > Brake > Utility| Tester Display |
|---|
| Vehicle Control History (RoB) |
|
| 4. | CHECK VEHICLE CONTROL HISTORY |
(a) Using the Techstream, check for Vehicle Control History.
Chassis > Brake > Utility| Tester Display |
|---|
| Vehicle Control History (RoB) |
HINT:
The rear speed sensor RH and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.
If the rear speed sensor RH and rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.
| Result | Proceed to |
|---|---|
| X0454 is not output | A |
| X0454 is output | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE REAR SPEED SENSOR RH |
READ NEXT:
RR Speed Sensor Wrong Installation (X0454)
DESCRIPTION Code Tester Display Measurement Item Trouble Area X0454 RR Speed Sensor Wrong Installation History of rear speed sensor RH being installed incorrectly Rear Speed Sensor
Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing th
Slip Indicator Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the slip indicator light remains on but no DTCs are output. The skid control ECU (brake actuator assembly) controls the slip indicator light in t
SEE MORE:
Brake Hydraulic Pressure Malfunction (C164F)
DESCRIPTION When a malfunction signal sent from the skid control ECU via CAN communication is detected by the clearance warning ECU assembly, DTC C164F is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C164F Brake Hydraulic Pressure Malfunction Brake master cyli
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum warning switch assembly removal/installation are shown below. Necessary Procedures After Parts Re
