Lexus ES manuals

Lexus ES: Removal

Lexus ES (XZ10) Service Manual / Vehicle Interior / Lighting (ext) / Headlight Assembly (for Bulb Type Turn Signal Light) / Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front bumper assembly
  • Measure ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Parking Support Alert System (for HV Model)
  • Parking Support Brake System (for HV Model)

Front television camera view adjustment

Panoramic View Monitor System (for HV Model)

for Initialization

for Calibration

Headlight ECU sub-assembly LH

Synchronize the vehicle information

Lighting system (for HV Model)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*1: for TMMK Made

Front bumper assembly
  • Measure ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Parking Support Alert System (for Gasoline Model)
  • Parking Support Brake System (for Gasoline Model)

Front television camera view adjustment

Panoramic View Monitor System (for Gasoline Model)

for Initialization

for Calibration
  • Headlight ECU sub-assembly LH
  • Headlight assembly LH*1

Synchronize the vehicle information

Lighting System (for Gasoline Model)

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here

2. REMOVE COWL TOP PANEL INSULATOR

Click here

3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY

Click here

4. REMOVE HEADLIGHT ASSEMBLY

Click here

READ NEXT:

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE HEADLIGHT ECU SUB-ASSEMBLY Click h

 Adjustment

ADJUSTMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. PREPARE VEHICLE FOR HEADLIGHT AIM ADJUSTME

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL HEADLIGHT SEAL (for TMC Made) Clic

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *A for Type A - - *1 FUEL MAIN VALVE ASSEMBLY *2 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY *3 O-RING - - ● Non-reusable part - - ILLUSTRATION *A for Type B - - *1 FUEL MAIN VALVE ASSEMBLY *2 FUEL SUCTION TU

 Remote Engine Starter does not Operate

WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Before replacing the DCM (telematics transceiver), refer to Registration. Click here PROCEDURE 1. CHECK SMART KEY SYSTEM (for Start Function) (a) Check that the engine can be started by pressing the power switch. Result Proceed to E

© 2016-2026 Copyright www.lexguide.net