Lexus ES: Receiver Error (C2176)
Lexus ES (XZ10) Service Manual / Suspension / Tire Pressure Monitoring / Tire Pressure Warning System(for Gasoline Model) / Receiver Error (C2176)
DESCRIPTION
Tire pressure warning valve and transmitter signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C2176 | Receiver Error | Malfunction in the tire pressure warning ECU and receiver internal circuit | Tire pressure warning ECU and receiver | - |
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs and number of the transmitters (4 or 5) stored in the old ECU using the Techstream and write them down before removal.
-
It is necessary to perform initialization
.gif)
after registration of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
PROCEDURE
| 1. | CHECK DTC OUTPUT (C2176) |
(a) Clear the DTCs.
Chassis > Tire Pressure Monitor > Clear DTCs(b) Turn the engine switch off.
(c) Turn the engine switch on (IG) and check for DTCs.
Chassis > Tire Pressure Monitor > Trouble Codes| Result | Proceed to |
|---|---|
| C2176 is not output | A |
| C2176 is output | B |
| A | .gif) | END |
| B | | REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER |
READ NEXT:
Initialization not Completed (C2177)
DESCRIPTION Initialization is necessary if one of the following occurs:
The tire pressure warning ECU and receiver is replaced.
A tire pressure warning valve and transmitter is replaced.
Tires
Vehicle Speed Information Communication Lost (C2178)
DESCRIPTION The tire pressure warning ECU and receiver receives signals from the combination meter assembly via CAN communication. If a malfunction occurs in this communication line, DTC C2178 is outp
Tire Pressure Monitor ECU Communication Stop (C2179)
DESCRIPTION The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line. DTC No. Detection Item DTC Detection Condition Troubl
SEE MORE:
Mechanical System Tests
MECHANICAL SYSTEM TESTS STALL SPEED TEST CAUTION:
Do not perform a stall test if there are any people or objects near the vehicle.
The vehicle could begin moving suddenly, resulting in a serious accident.
Do not perform a stall test if any wheel chocks are out of position.
The vehicle
Operation Check
OPERATION CHECK PKSB OFF INDICATOR LIGHT OPERATION CHECK (a) Turn the power switch on (IG). (b) Turn the parking support brake system off and confirm that the PKSB OFF indicator in the combination meter illuminates. HINT: If the parking support brake system is not set to off in the customize settin
© 2016-2026 Copyright www.lexguide.net
