Lexus ES manuals

Lexus ES: Rear Right Center Sensor Malfunction (C1AE8)

DESCRIPTION

The rear center ultrasonic sensor RH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor RH. If the rear center ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AE8

Rear Right Center Sensor Malfunction

A malfunction of the rear center ultrasonic sensor RH.

  • Rear center ultrasonic sensor RH
  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If DTCs are output after repairs, turn the power switch on (IG) and the parking support alert system on. Then clear the DTCs.

Click here

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

Only DTC C1AE8 is output

A

DTC C1AE8 and C1AED are output

B

No DTCs are output

C

B

GO TO DTC (C1AED)

C

USE SIMULATION METHOD TO CHECK

A

2.

REPLACE REAR CENTER ULTRASONIC SENSOR RH

(a) Replace the rear center ultrasonic sensor RH with new or a known good one.

Click here

HINT:

All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.

NEXT

3.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(b) Check for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

Result

Proceed to

DTC C1AE8 is output

A

No DTCs are output

B

A

REPLACE CLEARANCE WARNING ECU ASSEMBLY

B

END (REAR RIGHT CENTER SENSOR WAS DEFECTIVE)

READ NEXT:

 Rear Right Sensor Malfunction (C1AE9)

DESCRIPTION The rear corner ultrasonic sensor RH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor

 Front Sensor Communication Malfunction (C1AEC)

DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor. DTC No. De

 Rear Sensor Communication Malfunction (C1AED)

DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. Dete

SEE MORE:

 Front Camera Response Malfunction (C2A6D)

DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the front television camera assembly. This DTC is stored when the output of the front television camera assembly does not match the expected output. DTC No. Detection Item DTC

 Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION When troubleshooting OBD II (On-Board Diagnostics) vehicles, the Techstream (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read. OBD II regulations re

© 2016-2026 Copyright www.lexguide.net