Lexus ES: Propeller Shaft System
Lexus ES (XZ10) Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Propeller Shaft Assembly| Symptom | Suspected Area | Link |
|---|---|---|
| Noise or Vibration | Intermediate shaft (Runout) | |
| Propeller shaft (Runout)*a | | |
| Propeller shaft (Runout)*b | | |
| Joint angle | .gif) |
*a: for Front Side
*b: for Rear Side
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR DRIVE SHAFT ASSEMBLY LH *2 REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH *3 REAR DIFFERENTIAL CARRIER ASSEMBLY - - Toyota Genuine Differe
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedure for th
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
Some Data List values may vary significantly if there are slight differences in the environment in which the vehicle is operating when measurements are obtained. Variations may also occur due to aging of the vehicle. Due to these considerations, it is not
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MOTOR COVER (a) Disconnect the connector. (b) Disengage the 2 clamps. (c) Disengage the 4 claws to remove the motor cover as shown in the illustration. Remove in this Direction 2. REMOVE SWING GRILLE ACTUATOR ASSEMBLY (a) Remove the swing gril
© 2016-2025 Copyright www.lexguide.net
