Lexus ES: Problem Symptoms Table
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System (for Gasoline Model Without Memory) / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the battery voltage is low, the mirror heater function may not operate.
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| Electrical remote control mirror does not operate | Outer mirror switch assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - | |
| Mirror heater does not operate | Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" | |
| Automatic glare-resistant EC mirror does not operate | Inner rear view mirror assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - |
.gif)
READ NEXT:
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace th
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY Click here
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive func
SEE MORE:
Red Indicator Remains On
DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE 1. CHECK DTC (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the po
Hybrid vehicle driving tips
For economical and ecological
driving, pay attention to the following
points:
Using Eco drive mode
When using Eco drive mode, the
torque corresponding to the accelerator
pedal depression amount can be
generated more smoothly than it is in
normal conditions. In addition, the
operation of the
© 2016-2026 Copyright www.lexguide.net
