Lexus ES: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
-
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
-
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Fuel Lid Opener System
| Symptom | Suspected Area | Link |
| Fuel lid opener does not lock/unlock | Proceed to "Fuel Lid Opener does not Operate" | |
| Messages are not displayed on the multi-information display in the combination meter assembly | SFI system | |
| Combination meter assembly | |
| ECM | |
| Wire harness or connector | - |
READ NEXT:
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
DESCRIPTION When the trunk and fuel switch assembly (fuel lid opener switch) is pushed, a trunk and fuel switch assembly (fuel lid opener switch) signal is sent to the ECM. The ECM turns on the FUEL O
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT REAR DOOR ILLUMINATION LIGHT LH (REAR DOOR OUTSIDE HANDLE ASSEMBLY LH) *a Component without harness connected (Rear Door Illumination Light LH (Rear Door Outside Handle Assembly LH)) (a) Connect 4 dry-cell batteries (1.5 V) in series. NOTICE: Do not use recha
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY (a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head sub-assembly contacts the cylinder block sub-assembly, intake manifold and exhaust manifold (TWC: Front Catalyst). *
© 2016-2026 Copyright www.lexguide.net
