Lexus ES: Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Lane Control System (for HV Model) | |
| Lane Control System (for Gasoline Model) | |
| Parking Support Brake System (for HV Model) | |
| Parking Support Brake System (for Gasoline Model) | |
| Parking Assist Monitor System (for HV Model) | |
| Parking Assist Monitor System (for Gasoline Model) | |
| Panoramic View Monitor System (for HV Model) | |
| Panoramic View Monitor System (for Gasoline Model) | |
| Pre-collision System (for HV Model) | |
| Pre-collision System (for Gasoline Model) | |
| Power Trunk Lid System (for HV Model) | |
| Power Trunk Lid System (for Gasoline Model) | |
| Lighting System (for HV Model) | |
| Lighting System (for Gasoline Model) |
.gif)
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. for Gasoline Model: Click here for HV Model: Click here HINT: Use the tabl
System Diagram
SYSTEM DIAGRAM
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive func
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE MOUNTING INSULATOR (a) Engage the clamp and install the vacuum hose to the rear engine mounting insulator. (b) Install the wire harness clamp bracket to the rear engine mounting insulator with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (c) Al
Evaporative Emission System Switching Valve Control Circuit Actuator Stuck Off (P24187F)
DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P24187F Evaporative Emission System Switching Valve Control Circuit Actuator Stuck Off Following condition met during key-off EVAP monitor:
EVAP pressure change when vent valve closed (o
