Lexus ES: Precaution
PRECAUTION
HINT:
- Any digits beyond the 1/100 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
- When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Stud Bolt - - *1 VALVE SPRING RETAINER LOCK *2 VALVE SPRING RETAINER *3 INNER COMPRESSION SPRING *4 INTAKE VALVE STEM OIL SEAL *5 VALV
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during
Inspection
INSPECTION CAUTION / NOTICE / HINT HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. INSPECT CYLINDER HEAD LH (a) Using a precision straig
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL PIPE PLUG SUB-ASSEMBLY (a) Install a new O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring to the fuel pipe plug sub-assembly as shown in the illustration. *1 Fuel Pipe Plug Sub-assembly *2
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY (a) Disconnect the A38 windshield wiper motor assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Descrip
© 2016-2025 Copyright www.lexguide.net
