Lexus ES manuals

Lexus ES: Power Window Regulator Motor (for Rear Door)

Lexus ES (XZ10) Service Manual / Vehicle Interior / Window / Glass / Power Window Regulator Motor (for Rear Door)

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 COURTESY LIGHT ASSEMBLY *2 REAR DOOR TRIM BOARD SUB-ASSEMBLY *3 REAR DOOR TRIM UPPER PAD *4 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UP

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during pow

 Inspection

INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR) (a) Connect a positive (+) lead from the auxiliary battery to connector terminal 2. NOTICE: Do not connect a

SEE MORE:

 A/F (O2) Sensor Circuit Bank 1 Sensor 2 Circuit Current (Voltage) Below Threshold (P013616,P013A7C)

DESCRIPTION Refer to DTC P003612. Click here HINT: Although the DTC title say O2 sensor, this DTC relate to the air fuel ratio sensor (sensor 2). DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P013616 A/F (O2) Sensor Circuit Bank 1 Sensor 2 Circuit

 Installation

INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Install the flow shutting valve (No. 1 water by-pass hose) with the bolt. Torque: 19 N·m {194 kgf·cm, 14 ft·lbf} (b) Connect the flow shutting valve (No. 1 water by-pass hose) connector. (c) Connect the flow shu

© 2016-2026 Copyright www.lexguide.net