Lexus ES: Outer Rear View Mirror Glass
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 OUTER MIRROR - -
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR (a) Apply protective tape
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER MIRROR RH (a) Check the outer mirror heater operation. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester
SEE MORE:
Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete. DTC No. Detection Item DTC Detection Condition Trouble Area C1AF9 Blind Spot Monito
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below. Necessary Procedures After Part
© 2016-2026 Copyright www.lexguide.net
