Lexus ES: Operation Check
OPERATION CHECK
CHECK TIRE PRESSURE WARNING SYSTEM FUNCTION
(a) Using the Data List, check that the current tire pressure is normal.
Click here .gif)
(1) Slowly reduce the tire pressure of the front or rear tires and check that the tire pressure on the Data List changes.
(2) Further reduce the tire pressure and check that the warning light illuminates.
(b) After reducing the tire pressure, set the tire pressure to the specified value.
Click here
READ NEXT:
Registration
REGISTRATION PROCEDURE 1. BEFORE REGISTRATION NOTICE:
The transmitter ID is written on the tire pressure warning valve and transmitter. It is not possible to read the transmitter ID after installin
Initialization
INITIALIZATION NOTICE:
Initialization can be confirmed through the tire pressure warning light.
If the engine switch is turned off during initialization, the tire pressure warning ECU and receive
Test Mode Procedure
TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT:
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode)
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/
Data List / Active Test
DATA LIST / ACTIVE TEST READ DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or stat
© 2016-2026 Copyright www.lexguide.net
