Lexus ES manuals

Lexus ES: No Sound can be Heard from Speakers

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System (for Hv Model) / No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player and the radio re

 Noise Occurs

PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source can be determined. NG

 Operation Check

OPERATION CHECK CHECK NAVIGATION SYSTEM NORMAL CONDITION (a) If the cause of a symptom is any of the following, the corresponding symptom is normal; it is not due to a malfunction. Symptom Answer

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY (a) Install the remote operation controller assembly with the 4 screws as shown in the illustration. Install in this Direction 2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here 3. INSTALL SHIFT LEVER KNOB SU

 Reverse Signal Circuit

DESCRIPTION The multi-display receives a reverse signal from the BK UP LP relay*1 or clearance warning ECU assembly*2. *1: w/o Parking Support Alert System *2: w/ Parking Support Alert System WIRING DIAGRAM for 8 inch display for 12.3 inch display w/ Parking Support Alert System CAUTION /

© 2016-2026 Copyright www.lexguide.net