Lexus ES manuals

Lexus ES: Luggage Door Hinge Torsion Bar

Lexus ES (XZ10) Service Manual / Vehicle Interior / Door / Hatch / Luggage Door Hinge Torsion Bar

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT FLOOR MAT *2 SPARE WHEEL COVER TRAY ILLUSTRATION *1 REAR FLOOR FINISH PLATE *2 LUGGAGE HOLD BELT STRIKER ASSEMBLY ILLUSTRATION

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lug

 Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: After installing the luggage door hinge torsion bar, use your hand to open and close the luggage door. Make sure the luggage door can open and close smooth

SEE MORE:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3 with the ignition switch off. (b) Start the engine and run it at idle. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Active Test. HINT: Refer to the Techstream opera

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect

© 2016-2026 Copyright www.lexguide.net