Lexus ES: Lost Communication with Brake System Control Module (U0129,U0140,U0293)
DESCRIPTION
These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | The vehicle approaching speaker controller does not receive data from the skid control ECU (brake booster with master cylinder assembly) for approximately 10 seconds or more. |
|
| U0140 | Lost Communication with Body Control Module | The vehicle approaching speaker controller does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. |
|
| U0293 | Lost Communication with Hybrid/EV Powertrain Control Module | The vehicle approaching speaker controller does not receive data from the hybrid vehicle control ECU for approximately 10 seconds or more. |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Trouble Codes.
(e) Check for DTCs.
Body Electrical > Vehicle Proximity Notification System > Trouble CodesHINT:
When DTCs indicating a CAN communication system malfunction are output, perform troubleshooting for the CAN communication system before the vehicle proximity notification system.
| NEXT | .gif) | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
There is No Sound Made
DESCRIPTION Based on signals received from each ECU, the vehicle approaching speaker controller outputs warning sounds through the vehicle approaching speaker assembly. WIRING DIAGRAM CAUTION / NOTIC
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY Click here 2. REMOVE NO. 2 SURGE TANK STAY Click here 3. SEPARATE ENGINE WIRE (a) Remove the 2 bolts and separate the engine wire. (b) Remove the bolt and separate the earth wire. 4. DISCONNECT AIR TUBE
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna assembly removal/installation are shown below. Necessary Procedure After Part
