Lexus ES: Lost Communication with Brake System Control Module (U0129)
DESCRIPTION
The tire pressure warning ECU and receiver receives signals from the skid control ECU (brake booster with master cylinder assembly) via CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU (brake booster with master cylinder assembly) | -
CAN communication system
-
Skid control ECU (Brake booster with master cylinder assembly)
| - |
PROCEDURE
| 1. | GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN communication system.
Click here
| NEXT | | END |
READ NEXT:
DESCRIPTION The tire pressure warning ECU and receiver identifies the tire position for each tire pressure warning valve and transmitter according to the wheel speed signals from the skid control ECU
DESCRIPTION If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring is disabled at the sa
DESCRIPTION When "Change Wheel Set" is selected on the multi-information display and the "OK" switch (steering pad switch assembly) is pushed and held, the system enters ID registration mode and the t
SEE MORE:
CHECK MODE PROCEDURE HINT: Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode. NOTICE: All of the stored DTCs and Freeze Frame Data are cleared if: 1) the ECM is changed from normal mode to check
INSTALLATION PROCEDURE 1. INSTALL INVERTER WATER PUMP ASSEMBLY (a) Connect the No. 2 inverter cooling hose and No. 3 inverter cooling hose to the inverter water pump assembly and slide the 2 clips to secure them. NOTICE:
Make sure to align the alignment marks of the hoses with the ribs of th
© 2016-2026 Copyright www.lexguide.net
