Lexus ES: Utility
UTILITY
CANCEL COMMUNICATION FUNCTION PAUSING
HINT:
This function is used to cancel communication function pausing mode.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Utility / Cancel Communication Function Pausing.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| Cancel Communication Function Pausing |
ALL READINESS
HINT:
- With "All Readiness", you can check whether or not the DTC judgment has been completed by using the Techstream.
- You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs even if no DTCs are stored.
(e) Turn the power switch off and wait for 2 minutes or more.
(f) Turn the power switch on (IG).
(g) Perform the DTC judgment driving pattern to run the DTC judgment.
(h) Enter the following menus: Powertrain / Telematics / Utility / All Readiness.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| All Readiness |
(i) Input the DTC to be confirmed.
(j) Check the DTC judgment result.
| Techstream Display | Description |
|---|---|
| If the judgment result shows Incomplete or N/A, perform the DTC confirmation driving pattern again. | |
| Normal |
|
| Abnormal |
|
| Incomplete |
|
| N/A |
|
(k) Turn the power switch off.
READ NEXT:
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
Brake
h1 {color:red;} h2 {color:blue;} h3 {color:green;}
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY NOTICE: This inspection is for checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked. (a) Measure the
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis
