Lexus ES: Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Telematics / Telematics System (for Gasoline Model) / Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U014087 | Lost Communication with Body Control Module Missing Message | CAN reception error | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | CAN reception error | CAN communication system |
| U016387 | Lost Communication with Navigation Control Module Missing Message | CAN reception error | CAN communication system |
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(b) Recheck for DTCs and check if the same DTCs are output again.
Body Electrical > Telematics > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTCs are output. | B |
| A |  | USE SIMULATION METHOD TO CHECK |
| B | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
Utility
UTILITY CANCEL COMMUNICATION FUNCTION PAUSING HINT: This function is used to cancel communication function pausing mode. (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c)
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
Warning Notification Function Malfunction
PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function. Result Proceed to
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL INJECTOR SEAL (a) Apply engine conditioner to the area shown in the illustration. Using a piece of cloth, clean carbon deposits from the direct fuel injector assembly and its grooves. NOTICE:
Do not clean the tip of the direct fuel injector assembly.
Installation
INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Using a union nut wrench, install the suspension tower damper to the vehicle with the 2 nuts. Torque: Specified tightening torque : 35 N·m {357 kgf·cm, 26 ft·lbf} NOTICE: Do not extend or compress the damper. HINT:
Calculate th
© 2016-2023 Copyright www.lexguide.net
