Lexus ES: Lost Communication with Body Control Module "B" Missing Message (U014287,U015587,U020887)
DESCRIPTION
The multiplex tilt and telescopic ECU receives signals from the main body ECU (multiplex network body ECU), combination meter assembly and position control ECU assembly (driver seat) via CAN communication.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
U014287 | Lost Communication with Body Control Module "B" Missing Message | One of the following conditions is met: -
Signals (memory-related data) from the main body ECU (multiplex network body ECU) are interrupted for 3.3 seconds.
-
Signals (IG switch signals) from the main body ECU (multiplex network body ECU) are interrupted for 10 seconds or more.
| -
CAN communication system
-
Main body ECU (Multiplex network body ECU)
|
U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | Signals from the combination meter assembly are interrupted for 10 seconds or more. | -
CAN communication system
-
Combination meter assembly
|
U020887 | Lost Communication with "Seat Control Module A" Missing Message | Signals (memory or recall request signal) received from the position control ECU assembly (driver seat) are interrupted for 10 seconds or more. | -
CAN communication system
-
Position control ECU assembly (Driver seat)
|
PROCEDURE
1. | GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN Communication System.
Click here
NEXT | | END |
READ NEXT:
DESCRIPTION Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in
DESCRIPTION When the power switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
SEE MORE:
DESCRIPTION
DTC C1ABE is stored when the blind spot monitor sensor LH detects a short to ground or open in the RCTA buzzer (blind spot monitor buzzer) circuit.
DTC No. Detection Item DTC Detection Condition Trouble Area C1ABE Short to GND or Open in Buzzer Both of the followi
DESCRIPTION The sliding roof ECU (sliding roof drive gear sub-assembly) operates its built-in motor according to the sliding roof switch (map light sub-assembly) operation. Using the sliding roof switch (map light sub-assembly), if the sliding roof can be operated normally when 45 seconds or more ha
© 2016-2024 Copyright www.lexguide.net