Lexus ES: Left Front Wheel Speed Sensor Signal Stuck High (C050024)
Lexus ES (XZ10) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Left Front Wheel Speed Sensor Signal Stuck High (C050024)
DESCRIPTION
Refer to DTC C050012
Click here .gif)
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C050024 | Left Front Wheel Speed Sensor Signal Stuck High | The speed sensor signal is not within the specified range for 5 seconds or more. | Front speed sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Click here
PROCEDURE
| 1. | REPLACE FRONT SPEED SENSOR LH |
(a) Replace the front speed sensor LH.
Click here
| NEXT |  | END |
READ NEXT:
Left Front Wheel Speed Sensor Internal Electronic Failure (C050049)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC
Right Front Wheel Speed Sensor Circuit Short to Battery (C050612)
DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control. The speed sensor detects the magnetic
Right Front Wheel Speed Sensor Circuit Short to Ground or Open (C050614)
DESCRIPTION Refer to DTC C050612 Click here DTC No. Detection Item DTC Detection Condition Trouble Area C050614 Right Front Wheel Speed Sensor Circuit Short to Ground or Open A shor
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
Installation
INSTALLATION PROCEDURE 1. INSTALL ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Install the electric vehicle battery plug assembly to the HV battery with the bolt. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (b) Connect the hybrid battery
© 2016-2026 Copyright www.lexguide.net
