Lexus ES: Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received (U059481)
DESCRIPTION
If the hybrid vehicle control ECU cannot recognize the forward recognition camera. DTC U059481 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| U059481 | Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received | Approximately 17 seconds or more after the power switch is turned on (IG), the hybrid vehicle control ECU cannot recognize the forward recognition camera for approximately 2 seconds or more. | Hybrid vehicle control ECU | Does not come on | Radar Cruise2 |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the hybrid vehicle control ECU, refer to Registration.
Click here .gif)
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Clear the DTCs.
Powertrain > Radar Cruise2 > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Powertrain > Radar Cruise2 > Trouble Codes| Result | Proceed to |
|---|---|
| DTC U059481 is not output | A |
| DTC U059481 is output | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE HYBRID VEHICLE CONTROL ECU |
READ NEXT:
Steering Pad Switch Circuit
DESCRIPTION
The steering pad switch assembly outputs the dynamic cruise control on/off signal and various control signals to the hybrid vehicle control ECU.
The hybrid vehicle control ECU control
Distance Control Switch Circuit
DESCRIPTION The vehicle-to-vehicle distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The vehicle-to-vehicle distance control switch is installed in the
Cruise Main Indicator Light Circuit
DESCRIPTION When the dynamic radar cruise control system is turned on using the cruise control main switch, the cruise control indicator (vehicle-to-vehicle distance control mode) illuminates. The hyb
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION WIRE (a) Coat the O-ring of the transmission wire with Toyota Genuine ATF WS. (b) Install the transmission wire to the automatic transaxle case sub-assembly with the bolt. Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} (c) Connect the transmi
"No GPS signal" mark is displayed
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
When replacing the radio receiver assembly, always re
