Lexus ES: Internal Control Module Software Incompatibility Invalid / Incompatible Software Component (U030057)
DESCRIPTION
The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication.
If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores DTC U030057.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030057 | Internal Control Module Software Incompatibility Invalid / Incompatible Software Component | While the lane control system is on, vehicle information sent from the hybrid vehicle control ECU does not match that stored in the forward recognition camera. | Front camera system |
PROCEDURE
| 1. | GO TO FRONT CAMERA SYSTEM |
HINT:
If DTC U030057 is output by the lane control system, perform troubleshooting for the front camera system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Steering Pad Switch Circuit
DESCRIPTION The forward recognition camera receives LTA main switch signals from the steering pad switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: The vehicle is equipped with a Supple
Indicator Circuit
DESCRIPTION The forward recognition camera sends indicator illumination request signals to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE:
When replacing the f
SEE MORE:
Pressure Control Solenoid "L" Circuit Short to Ground or Open (P08BA14)
DESCRIPTION Refer to DTC P08BA12. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P08BA14 Pressure Control Solenoid "L" Circuit Short to Ground or Open While the vehicle is being driven so that gear changes occur, a short to ground or o
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. Lithium Soap Base Glycol Grease (b) Install the No. 2 steering rack boot to the groove on the rack housing. NOTICE:
Be
