Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 2 CLEARANCE WARNING BUZZER
(a) Connect the connector.
(b) Engage the clamp to install the No. 2 clearance warning buzzer.
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Click here .gif)
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
Click here
4. INSTALL REAR SEAT SHOULDER BELT COVER
Click here
5. INSTALL CENTER STOP LIGHT SET (w/o Rear Sunshade)
Click here
6. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
Click here
7. CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
Click here
9. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL REAR SEAT SIDE GARNISH LH
Click here
11. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
12. INSTALL REAR DOOR SCUFF PLATE LH (for HV Model)
Click here
13. INSTALL REAR DOOR SCUFF PLATE LH (for Gasoline Model)
Click here
14. INSTALL REAR DOOR SCUFF PLATE RH (for HV Model)
HINT:
Use the same procedure as for the LH side.
15. INSTALL REAR DOOR SCUFF PLATE RH (for Gasoline Model)
HINT:
Use the same procedure as for the LH side.
16. INSTALL REAR SEAT ASSEMBLY
Click here
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No.
Components
COMPONENTS ILLUSTRATION *1 CLEARANCE WARNING ECU ASSEMBLY *2 ECU INTEGRATION BOX RH *3 GLOVE COMPARTMENT DOOR ASSEMBLY - -
SEE MORE:
Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure (P070562)
DESCRIPTION The shift lever position sensor sends 7 different switch signals to the hybrid vehicle control ECU. The hybrid vehicle control ECU uses these signals to detect the shift lever position (P, R, N or D). The hybrid vehicle control ECU also uses this information to determine the intended dir
Components
COMPONENTS ILLUSTRATION *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 FRONT WHEEL OPENING EXTENSION PAD RH *3 NO. 1 ENGINE UNDER COVER *4 NO. 2 ENGINE UNDER COVER ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 FRONT BUMPER ENERGY ABSORBER
