Lexus ES: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR ILLUMINATION LIGHT (FRONT DOOR OUTSIDE HANDLE ASSEMBLY)
Click here .gif)
2. INSTALL FRONT DOOR SERVICE HOLE COVER
Click here
3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
4. INSTALL COURTESY LIGHT ASSEMBLY
Click here
5. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
6. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
7. INSTALL NO. 2 DOOR TRIM PAD
Click here
8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS:
Click here
for A25A-FXS:
Click here
for A25A-FKS:
Click here
9. INSPECT POWER WINDOW OPERATION
for HV Model:
Click here
for Gasoline Model:
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COURTESY LIGHT ASSEMBLY *2 REAR DOOR ILLUMINATION LIGHT (REAR DOOR OUTSIDE HANDLE ASSEMBLY) *3 REAR DOOR SERVICE HOLE COVER *4 REAR DOOR TRIM BOARD SUB-A
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR ILLUMINATION LIGHT LH (REAR DOOR OUTSIDE HANDLE ASSEMBLY LH) *a Component without harness connected (Rear Door Illumination Light LH (Rear Door Outside
SEE MORE:
Torque Sensor1 (C1511-C1514,C1521-C1523,C1528,C1531-C1555)
DESCRIPTION While torque sensor system, motor system or ECU system malfunctions are detected, the fail-safe function suspends power assist. However, power assist continues with limited assistance amount if only C1533 or C1534 is output. DTC No. Detection Item DTC Detection Condition Trouble
Installation
INSTALLATION PROCEDURE 1. INSTALL STARTER ASSEMBLY (a) Install the starter assembly to the cylinder block sub-assembly with the 2 bolts. Torque: 46 N·m {469 kgf·cm, 34 ft·lbf} (b) Connect the No. 2 engine wire to terminal 30 with the nut. Torque: 9.8 N·m {100 kgf·cm, 87 in·lbf} (c) Close the
