Lexus ES: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. INSTALL HEADLIGHT ASSEMBLY
Click here
2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
Click here
3. INSTALL COWL TOP PANEL INSULATOR
Click here
4. INSTALL FRONT BUMPER ASSEMBLY
Click here
5. PERFORM INITIALIZATION
for HV Model:
Click here
for Gasoline Model:
Click here
6. ADJUST HEADLIGHT AIMING
Click here
READ NEXT:
REPAIR CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
If the installation area of the headlight assembly is damage
COMPONENTS ILLUSTRATION *1 COWL TOP PANEL INSULATOR *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY *3 HEADLIGHT ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - I
SEE MORE:
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System (for Gasoline Model)
DESCRIPTION The rear center ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor LH. If the rear center ultrasonic sensor LH has an open circuit or other malfunction, it will not fu
© 2016-2026 Copyright www.lexguide.net
