Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL RAIN SENSOR TAPE
HINT:
The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated with foreign matter.
(a) Clean the sensing portion of the rain sensor with a piece of cloth.
(b) Peel off the smaller release sheet, and then attach the rain sensor tape to the sensing portion of the rain sensor as shown in the illustration.
.png) | Rain Sensor Tape |
HINT:
Use your fingers to push out any air bubbles from under the tape.
Standard Clearance| Area | Measurement |
|---|---|
| A | 14.4 mm (0.567 in.) |
| B | 7.25 mm (0.285 in.) |
2. INSTALL RAIN SENSOR
(a) Clean the windshield glass with a piece of cloth.
NOTICE:
- Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.
- If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.
(b) When installing a new rain sensor or when the rain sensor tape has been replaced:
(1) Peel off the release sheet.
HINT:
Do not touch the rain sensor tape surfaces.
(c) Connect the connector.
(d) Gradually attach the rain sensor to the windshield glass surface in the direction indicated by the arrow (1) shown in the illustration to prevent air bubbles from forming between them.
| *a | Stopper |
.png) | Install in this Direction (1) |
.png) | Install in this Direction (2) |
HINT:
Do not touch the rain sensor tape surface or windshield glass surface.
(e) Push in the stopper in the direction indicated by the arrow (2) shown in the illustration to install the rain sensor.
3. INSTALL RAIN SENSOR COVER
| (a) Engage the 2 claws and guide to install the rain sensor cover. |
|
READ NEXT:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WIPER RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Co
Components
COMPONENTS ILLUSTRATION *1 LEVEL WARNING SWITCH ASSEMBLY - -
SEE MORE:
Auto ID Under Registration (C2128)
DESCRIPTION When ID registration is being performed via the automatic ID registration function, the tire pressure warning ECU and receiver stores C2128 and the tire pressure warning light flashes for 1 minute and then illuminates. When the tire pressure warning ECU receives data from all registered
Jam Protection Function does not Operate
DESCRIPTION This symptom may occur for any of the power windows. The jam protection function operates within a specified range during the manual up or auto up operation. CAUTION / NOTICE / HINT NOTICE:
If a power window regulator motor assembly has been replaced with a new one, initialize the pow
