Lexus ES: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
(a) Engage the 2 guides and claw.
(b) Install the outer rear view mirror assembly with the 3 nuts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Engage the clamp.
(d) Connect the connector.
2. INSTALL OUTER MIRROR INSTALL HOLE COVER
(a) Engage the clip and 2 claws.
(b) Install the outer mirror install hole cover with the screw.
(c) Engage the clamp.
(d) w/ Panoramic View Monitor System:
(1) Connect the connector.
3. INSTALL HOLE PLUG
(a) Install the 2 hole plugs.
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here .gif)
5. INSTALL COURTESY LIGHT ASSEMBLY
Click here
6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
8. INSTALL NO. 2 DOOR TRIM PAD
Click here
9. PERFORM CALIBRATION (w/ Panoramic View Monitor System)
for Gasoline Model: Click here
for HV Model: Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Panoramic View Monitor System *B w/ Panoramic View Monitor System *1 OUTER MIRROR *2 OUTER MIRROR COVER ASSEMBLY *3 OUTER MIRROR LOWER COVER
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during out
SEE MORE:
Hybrid/EV Powertrain Control Module EEPROM Data Memory Failure (P062F44)
DESCRIPTION The hybrid vehicle control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction. If these DTCs are output, replace the hybrid vehicle control ECU. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicat
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: If the rear disc brake cylinder assembly has been disassembled, perform air bleeding for the rear disc brake cylinder assembly. for HV Model: Click here for Gasoline Model: Click here NOTICE:
Make sure not to scratch, damage or apply excessive force
