Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL TILT AND TELESCOPIC SWITCH
(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the tilt and telescopic connector to the tilt and telescopic switch.
(c) Connect the spiral cable connector to the spiral cable sub-assembly.
2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS: Click here .gif)
for A25A-FXS: Click here
for A25A-FKS: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY
Click here
4. INSPECT SRS WARNING LIGHT
for Gasoline Model: Click here
for HV Model: Click here
5. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for A25A-FXS *B for 2GR-FKS *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 FRONT WHEEL OPENING EXTENSION PAD RH *3 NO. 1 ENGINE UNDER COVER *4 NO.
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. INSPECT REAR DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboard joint.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Front Camera System DTC No. Detection Item Link C10001C Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range C10051C Control Module Internal Temperature Sensor "B" Circuit Circuit Voltage Out of Range C100A
