Lexus ES: Installation
Lexus ES (XZ10) Service Manual / Steering / Steering Column / Tilt And Telescopic Manual Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL TILT AND TELESCOPIC SWITCH
(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the tilt and telescopic connector to the tilt and telescopic switch.
(c) Connect the spiral cable connector to the spiral cable sub-assembly.
2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for Gasoline Model: Click here .gif)
for HV Model: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY
Click here
4. INSPECT SRS WARNING LIGHT
for Gasoline Model: Click here
for HV Model: Click here
5. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL TILT AND TELESCOPIC SWITCH (a) Engage the claw to install the tilt and telescopic switch. (b) Connect the tilt and telescopic connector to the tilt and telescopic swi
SEE MORE:
Pattern Select Switch EV Mode Circuit
DESCRIPTION The EV drive mode signal will be sent to the hybrid vehicle control ECU when the EV drive mode switch (NO. 3 combination switch assembly) is operated. If the specified conditions are met, the system enters EV drive mode and the vehicle will be driven using EV drive mode. This signal is t
Operation Check
OPERATION CHECK VEHICLE PROXIMITY NOTIFICATION SYSTEM OPERATION CHECK (a) System operation check (vehicle stopped) (1) Apply the parking brake. (2) Turn the power switch on (IG). (3) With the brake pedal depressed, confirm that the vehicle proximity notification system does not operate (produce a so
© 2016-2026 Copyright www.lexguide.net
