Lexus ES: Battery Current Sensor
Lexus ES (XZ10) Service Manual / Power Source & Network / A25a-fxs (battery / Charging) / Battery Current Sensor
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL BATTERY STATE SENSOR ASSEMBLY (a) Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder. (b) Connect the battery state
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during batt
Components
COMPONENTS ILLUSTRATION *1 BATTERY STATE SENSOR ASSEMBLY *2 WIRE HARNESS *3 BATTERY CURRENT SENSOR HOLDER *4 NO.2 FRAME WIRE Tightening torque for "Major areas involving bas
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR HINT: Perform "Inspection After Repair" after replacing the air fuel ratio sensor. Click here (a) Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly (TWC: Rear Catalyst). SST: 09224-00012 Torque: Specified tig
Monitor Drive Pattern
MONITOR DRIVE PATTERN MONITOR DRIVE PATTERN FOR ECT CAUTION: Perform the following procedure on a level surface while strictly observing all traffic laws and speed limits. HINT: Performing this drive pattern is one method to simulate ECM (ECT) malfunction detection conditions. Some DTCs may not be d
© 2016-2026 Copyright www.lexguide.net
